This is pretty straight forward The back pieces goes on first. It slides down onto the 3 hooks (see 1st image below) along the top edge and is then bolted in two places at the bottom The bottom piece is last, this just gets wedged under the back piece and gets secured in 2 clips (see one of them in the last image above) along the front edge.…

I’m reusing the original rear seat frame. It wasn’t in the best of shape in some places.. but overall it was decent First I removed all the rust and gave it a lick of paint In just a couple places the wire had worn/rusted through. I fixed this with a few bits of hollow tube around the worn steel and secured with zip ties. Next was to re-cover the seat.…