Removing upper control arm shaft and bushings.

Pictures say it all. Just use a chisel and hammer.


This metal outer sleeve gets replaced with a new bushing, so the damage doesn’t matter. The edge of the control arm shaft hole is burred, so will need filing down.

2 Comments
jeff | 28th June 2008 at 6:04 pm

There are a lot of pictures that don’t show up. I don’t know if it is my computer of the web server.

Jeff
VA

firebird67 | 29th June 2008 at 5:48 pm

You should be able to see them all shortly. Gradually updating all the old posts.

 
 


Leave a Comment