Welded the rear end section a bit more, but have decided I’m going to go round and do all the welds in one go (a few will be done when installing the panels to hold them in position and for body strength)… so I will proceed with installing more panels. Today I put in the new right side rear floor pan. This was very straightforward… Cut the old one out, cut the new floor oversized an inch or so and then plug weld into the the car.
I only filled a few of the plug weld holes (for now), but the floor is now very solid, and importantly, free from rust holes.
I’m glad to see you back to work on the Bird again. I’m spending most of my time on the kitchen right now. It’s been colder than usual, so I don’t mind being inside! Keep up the great work!