Archive: May 2008

Cavity waxing.

For this I used Bilt Hamber Dynax S-50 (anti-corrosion for cavities). Only way to tell if it’s really any good is to wait a few years. It certainly applied easily and got good coverage, and is definitely water repellent. When it dries it has a rubbery flexible feeling. Subframe inside. Before and After:…
Read the full post

Painting subframe (underneath).

POR-15 (rust preventative base coat): The base coat is really good stuff. Goes a long way and all brush strokes smooth out when drying.   POR-15 Chassis-Coat (UV protection top coat): The top coat is not quite as good as the base. It covers about half as much, and brushes strokes are inevitable. It does have a nice finish – colour and sheen – to it though. Once the subframe…
Read the full post

Painting subframe.

POR-15 (rust preventative base coat): The base coat is really good stuff. Goes a long way and all brush strokes smooth out when drying.   POR-15 Chassis-Coat (UV protection top coat): The top coat is not quite as good as the base. It’ll cover about half as much, and brushes strokes are inevitable. It does have a nice finish – colour and sheen – to it though. Once the subframe…
Read the full post

Cleaning subframe.

To strip all the subframe parts is kinda lengthy, and I forgot to take pictures. It is pretty simple: Remove the front wheels. Remove the shocks. Split the tie-rods and unbolt the steering pump and idler arm (entire steering assembly). Remove the sway bar. Chain the coil spring to the lower control arm and split the lower ball joint. Split the upper ball joint. Unbolt upper and lower control arms.…
Read the full post

Separating front subframe.

Once the engine and transmission are out, the subframe could be unbolted in four location from the body – 2 under the front seat pans and 2 directly under the firewall/bulkhead. These were very rusty so a big cheat bar on the socket wrench was used, and probably a whole can (not really…) of WD-40. The bushings are completely shot, there’s almost nothing left of them, they’ve rusted and disintegrated…
Read the full post

Engine and trans out.

Hoisted the engine and transmission out. Used two 1ton straps wrapped round the sump. Looks like it’s ready to slide out the slings, but it didn’t, it was fine.   Ready to be stripped and rebuilt, some time.…
Read the full post