Removing upper control arm shaft and bushings.

Tagged: 1967 Pontiac Firebird
19th May 2008

Pictures say it all. Just use a chisel and hammer.


This metal outer sleeve gets replaced with a new bushing, so the damage doesn’t matter. The edge of the control arm shaft hole is burred, so will need filing down.

Previous post:
Removing lower control arm ball joints and bushings.
Next post:
Preparing sub frame components for painting.
2 Comments
jeff | 28th June 2008 at 6:04 pm

There are a lot of pictures that don’t show up. I don’t know if it is my computer of the web server.

Jeff
VA

firebird67 | 29th June 2008 at 5:48 pm

You should be able to see them all shortly. Gradually updating all the old posts.

 
Reply to this comment
 


Leave a Comment